Displays instead of -ON- when the phone is in cellular (External) mode. Refer to Advanced Features for information on CAPCS.

*-Internal-

CALL

Displays when you receive a call. Press TALK to answer the call.

Called

Displays after an unanswered call.

Dialing

Displays as the phone dials after you press TALK.

Empty

Displays when you try to recall a phone number from a location that is empty. Press END to return to Standby.

Enter Name

Displays during storage operations to prompt you to enter a label for the memory location. Refer to Alphanumeric Memory Store.

Enter Number

Displays during memory store operations. Enter the number you want to store, then press TALK.

Enter Unlock Code

Displays when you try to lock your phone using FCN 51. Enter the Unlock Code, and press TALK. If you have not programmed an Unlock Code, use FCN 62 to do so before locking the phone.

Erase?

Displays with a stored phone number when you try to erase a memory location. Press TALK to erase the number and label.

Erased

Displays to confirm erasure after you have cleared a memory location. The address of the cleared location also displays.

Displays when there is a problem with your phone’s programming or circuitry. Write down Error number and bring phone in for service.

Displays when you attempt to access

External mode and Int Only is selected in FCN *. Change the setting in FCN *.

Displays after you press FCN. Enter the desired function number.

In Use

Displays with the In-Call timer when phone is in conversation mode.

Incorrect Security Code

Displays when you enter an incorrect security code. Press END, and begin again.

Invalid Code!!

Displays when you enter an Invalid Unlock Code when you attempt to lock your phone.

Key Locked

Displays while the keypad lock is on. Press END and t.

Key Tone

Displays when you attempt to change the key tone volume. Adjust the volume using s and t, then press END to save your setting.

Local Only

Displays instead of your phone number if Call Restriction level (FCN 61) is set to Local Only.

Locked

Displays while your phone is locked. Enter the 3-digit Unlock Code. If you forget your unlock code, program a new one. Refer to Creating an Unlock Code in the Features section.

Memory Full!!

Displays when you try to store information using Automatic Memory Store and all memory locations are full. Use Direct Memory Store to overwrite previously stored data.

MUTE

Displays when you turn your phone’s microphone off during conversation by pressing FCN. Press any key to turn it on.

No Service

Displays when you are out of range of cellular service. You cannot complete a call until you return to the service area.

ON

Displays in standby when CAPCS NAM (NAM3) is not programmed.

PIN Enable N.A.

Displays when you try to enable the PIN before programming one. Use FCN 65 to select a PIN.

PIN N.A.

Displays when you make a call with the PIN enabled if your service provider does not support the PIN feature.

Recall 1-9

Displays instead of your phone number if Call Restriction level (FCN 61) is set to Recall 1-9.

Recall 1-99

Displays instead of your phone number if Call Restriction level (FCN 61) is set to Recall 1-99.

Receive Only

Displays instead of your phone number if Call Restriction level (FCN 61) is set to Receive Only.

ROAM (A or B)

Indicates whether you are using system A or B when roaming.

ROAM INHIBIT

Displays when you select an alternate in System A/B Select and Roam Inhibit is programmed in NAM.

Security Code----

Prompts for Security Code. Enter , and press TALK.

Speaker Vol.

Displays when you use FCN 42 to change the speaker volume. Use # and * to adjust speaker volume, then press END to save.

Stored

Displays with a memory address to confirm a memory store.

Talk Timer

Displays when you reset your phone’s talk timers.

Voice